#9x3" Stripped Screw Hole Repair Made Easy: Permanently fix door sagging and hard to close doors caused by loose, stripped screws. This simple 3 minute door frame repair kit is just what you need! Everything You Need (except the drill): ZZem Screw door repair kit includes the correct size drill bit, Torx and Phillips bits, and size #9 brass hinge screws. (Works with #9 hinge screws ONLY, #9 screw measures 5/16” across the head of the screw). Multiple Uses: Door hinges, deadbolt strike plate, door lock strike plate, gate latch, gate hinge, handrail and shelf brackets that have wood backing. FOR WOOD and WOOD BY-PRODUCTS ONLY. Improve Home Security: Installs 3 inches deep into the wood frame of the house for strong door hinge reinforcement vs the door frame only, which is easily broken with a strong kick. Veteran Owned: Created by a US Navy Veteran, Contractor and Home Improvement Specialist. ZZem Screw door jamb repair kit, trusted for strength and integrity.

ZZem Screw was originally created out of frustration. Frustration in that door hinges and door lock screws will strip or wear out overtime, thus needing replacing. ZZem Screw was invented to fix this common household problem."

Created by a US Navy Veteran, Contractor and Home Improvement Specialist. ZZem Screw products are proudly made in the USA.

HOME REPAIR: ZZem Screw door repair hardware, allows you to replace your stripped door hinge screws with a sturdy, more effective screw that you'll never have to replace again. No more sagging or hard to close doors. ZZem screw is the fast easy solution for all doors throughout your home or business.

REVOLUTIONARY DOOR REPAIR AND SECURITY HARDWARE: By securing your strike plate, dead bolt, and hinges a total of 3 inches into the frame of the house, ZZem Screw door security hardware, will secure your doors from forced entry.

EASY INSTALLATION: You can install your ZZem Screw within minutes. All you need is a drill, we will supply the rest. ZZem Screw repair kits include the correct size drill bit, Torx and Phillips bits, and screws.

3 easy steps to install:

1) Remove hardware (strike plate, deadbolt, hinge), now mark the provided drill bit at 3" (masking tape works great). Drill a straight and level hole to 3". Tip, use a smaller drill bit for a pilot hole, helps with accuracy. Take your time.

2) Using the provided torx bit, insert into the ZZem Screw, set the drill to the lowest speed, screw it in so it's just below the surface.

3) Replace the hardware, use the provided phillips bit and #9 hinge screws and tighten. Set clutch on your drill to low, so as not strip the head of the screw.

For use with #9 hinge screws only (How to tell? The screw should measure 5/16” across screw head)

For wood and wood-by-products only

Available in Packs of 4, 8, or 12