Stop Mounts from Falling in Hot Cars: Replace worn or failed adhesive with high-bond mounting pads designed to securely hold dash cams, GPS units, and phone mounts on flat glass, metal, or plastic surfaces. Not intended for rear-view mirrors. Built for Automotive Heat & Weather: Engineered for vehicle environments, these pads withstand continuous temperatures up to 300°F (149°C) and resist sun exposure, cold weather, and vibration—helping keep your devices firmly attached. Customizable Fit for Any Mount Base: Each pad is 0.063" (1.6 mm) thick and can be trimmed to match your mount. Includes 2 square pads (2.83" × 2.83" / 72 × 72 mm) and 2 rectangular pads (2.83" × 1.42" / 72 × 36 mm)—ideal for front, rear, or dual-camera setups. Stronger Bond with Adhesion Promoters: Includes 4 adhesion promoter wipes to enhance bonding on plastic, ABS dashboards, and textured surfaces—helping reduce slippage and improve long-term stability. Easy Installation — Stronger Over Time: Clean with alcohol, apply adhesion promoter to the mount base, press firmly for 30 seconds, and allow at least 24 hours before mounting. Full bond strength develops over time for maximum holding power. Tired of your dash cam or GPS mount falling off in hot weather? These high-bond adhesive replacement pads are designed for automotive use, providing a secure hold on flat windshield and dashboard surfaces. With two square and two rectangular pads that can be trimmed to fit, this kit adapts to a wide range of dash cam and accessory bases. Built for heat resistance and paired with adhesion promoter wipes for enhanced bonding, this complete kit helps restore a stable, reliable mount—without drilling or screws.