Output 54.6V 3A, World Wide Input Voltage 100-240VAC 50/60Hz, red light -- charging, green light -- charge OK, it stop automatically when the battery is full 105℃ Output capacitor, global applicable AC Input voltage.100% full load aging test, Internal EMI filter, ripple minimum. The precision current between ±0.1A, the voltage tolerance is ±0.1V, absolutely not virtual marking. The charger Built-in simply fan, with radiating fin surrounding the board, dissipating the heat through the shell, So some hot on the shell when charging is very normal, but it is durable. The Charger protected: Battery detection function / reverse polarity protection, Our product is equipped with ‌thermal protection‌ and ‌overload protection‌ to prevent charging issues caused by overheating or excessive current Replace your broken charger or add an extra charger to charge in 2 locations without taking the original charger with you The one Lithium battery is normally 4.2 volts max, so 13S boards * 4.2volts = 54.6 volts. That way you can't overcharge the batteries as long as they are rated correctly. Make sure you have the correct female power connector for this: 5.5 x 2.1 mm plug To make your batteries last 10X longer, avoid using batteries below 35% and don’t charge above 85-90% Brand Name: Tangspower
Protections: Battery detection function / reverse polarity protection / over-temperature protection / overcharge protection / short circuit protection / low and higher voltage protection
LED Display: Red: In charging state, Green: Full Charged
Charge Mode: CC to CV
Use: lithium battery charger
Input Voltage: 100-240 V 50/60 HZ
Suitable Voltage / Frequency: 90-264 V 47 / 63Hz
Output Voltage: 54.6 V
Output current: 3A
Productivity: 80%
Fluctuation / Noise: <100MV
Working temperature: 0-40 ° C
Storage Temperature: -20-85 ° C
Working Nemi: 5% ~ 90% RH
Storage Humidity li ion battery charger: 5% ~ 90% RH
Housing material: PC
Use and maintenance of the charger :
1. When charging, first connector to the battery, then connect to AC; after full, cut off AC,
then pull the battery plug. If you pull the battery plug first while charging, especially when
the charging current is large (red light), it is very easy to damage the charger.
2. LED display after turning green, then charge for 2-3 hours.
3. Please do not run out of battery power, then charger. Otherwise the battery cannot
be protected or even damaged.
4. long-term shallow discharge battery, about 3 months, for a deep discharge, is the so-called re-lighting,
which is conducive to the activation of long-term immobile material in
the deep part of the battery. Luminous means that riding the controller battery undervoltage protection action
5. If your battery has not been used for a long time (2-3 months), please charge
the battery beforeusing it. Make sure your battery is not broken.
6.Please use the charger in a dry place in time.
7.When you do not use the charger, do not always connect the power supply.
8.Please confirm your battery, Because it is used to charge the lithium battery.
Do not use the charger on the LiFepo4 battery, otherwise the charger will be got incredibly hot.
To make your batteries last 10X longer, avoid using batteries below 35% and don’t charge above 85-90%