✔WET STICKING METHOD:
Large Car Sticker Applicable [Recommended Double Operation]
Use Tools: Watering can, clean rag, scraper, utility knife, air duct
Step 1: After cleaning the car body, spray water on the body part to be attached with watering can be used to reduce the viscosity of the sticker
and adjust the position.
Step 2: After confirming the position to be attached, transfer the transfer film (transparent film stuck on the reflective sticker)
together with the car sticker from right to left [or from top to bottom] and lift it to the car with a rag. On the table, and then affixed,
while smearing with a rag, while lifting the bottom paper.
Step 3: When encountering the door handle or anti-collision strip, the material should be cut and wrapped or loaded according to the situation.
Step 4: Adjust in time, after the general position of the figure is determined, use the scraper to repeatedly scrape off water and air bubbles.
When using the scraper, scrape from right to left; finally, remove the transparent transfer film.
Step 5: In the case of the door and the seam, use the utility knife to divide it and put it inward.
Step 6: Try to make the water in the car stickers dry, conditional heating can be moderately heated with a fan.
Tips:
Try not to expose to the sun within 24 hours, and do not wash the car within 48 hours.
If the paste is not good, it can be broken by a needle (you can poke a few times) and squeeze out the air.