RAISES THE SEAT 2 INCHES — IMPROVES PEDAL ANGLE AND REDUCES HIP STRAIN – Raising the seat changes the geometry of your pedal stroke, putting your legs in a more efficient position. Reduces hip and lower back strain on longer sessions. Reviewers report a noticeable improvement in pedalling efficiency and reduced discomfort after fitting. CNC MACHINED FROM SOLID HDPE — SET OF 4 – Machined from solid HDPE block. Will not corrode, rust, or degrade in saltwater or freshwater environments. Set of 4 risers — two front, two rear — to raise the full seat frame evenly by 2 inches. BOLT-ON INSTALL — NO DRILLING, UNDER 10 MINUTES – Remove the existing locking screws from your seat, slot the risers onto the ends of the seat frame, and refit the screws. No drilling, no modification to the kayak. Most installs take under 10 minutes. NO EFFECT ON STABILITY — MORE STORAGE SPACE UNDER THE SEAT – The 2-inch raise does not affect hull stability. The additional clearance under the seat creates usable storage space for tackle, tools, and gear that previously sat on the hull floor. FITS NATIVE WATERCRAFT SLAYER PROPEL AND MANTA RAY PROPEL WITH ALUMINIUM SEAT BASE – Fits Slayer Propel 10, Slayer Propel 10 LTE, Slayer Propel 13, Slayer Propel Max 10, Slayer Propel Max 12.5 (2022+), Slayer Propel LT, and Manta Ray Propel kayaks with the aluminium seat base. Also fits Pedalfish 10 and Revolve 10. Made in Australia.
Set of 4 seat risers for Native Watercraft Slayer and Manta Ray Propel kayaks. CNC machined from solid HDPE. Raises the seat 2 inches to improve pedal geometry, reduce hip and back strain, and create additional storage space under the seat.
Compatible kayaks (aluminium seat base required):
- Slayer Propel 10
- Slayer Propel 10 LTE
- Slayer Propel 13
- Slayer Propel Max 10
- Slayer Propel Max 12.5 (2022+)
- Slayer Propel LT
- Manta Ray Propel (aluminium seat base)
- Pedalfish 10
- Revolve 10
What the 2-inch raise does:
- Improves pedal stroke angle — more efficient output, less hip and lower back strain
- Creates additional storage space under the seat
- Raises fishing position for better rod control and easier stand-up/sit-down
- Improves sightlines over the water
- No effect on hull stability
Installation:
- Remove existing locking screws from the seat frame
- Slot risers onto the ends of the seat frame
- Refit screws
- No drilling required — under 10 minutes
Set of 4. CNC machined from solid HDPE. Made in Australia.