Environment: A temperature between 68ºF and 75ºF is ideal. Application: A dry, soft bristled brush works best. Use plenty of Cover All to get good coverage. If you see any repelling while it's wet, brush over it a few times until it fills in. Dry Time: Use 2 coats to ensure complete coverage. Ensure 2 hours of dry time between coats. A warm lamp hanging above it helps it to cure faster. You can also heat set Cover All by using a heat gun set on LOW, moving quickly and not too close. Be careful though, if you get it too hot, it can blister. Tinting: You can tint the Cover All by adding a few drops of our concentrated pigments and micas into it. Do this on the second coat. The first coat needs to be undiluted and pure for best adhesion. Curing: Cover All takes approximately 8 days before it becomes permanently adhered. No worries, you can still continue with your design 2 hours after the last coat. Cover All will continue to cure along with your other products as they dry. DO NOT pick or scratch off the Cover All while it is curing! Cover All is a clear, bonding prep coat that adheres to hard-to-cover surfaces. No need to sand or strip, just brush it on and watch it stick! Bonds to Metal, Steel, Glass, Acrylic, Ceramic, Plastic, Wood, Vinyl, Sublimation, and Powder Coats. Care- Store at room temperature in a dry place, out of direct sunlight. Do not subject the product to freezing or hot temperatures. CrystaLac products have a shelf life of 5 years after opening. Use in an environment above 68ºF. Saftey Info- Keep out of reach of children. Do not allow children to use the product unsupervised. If using a spray application method, wear proper eye and respiratory protection. All of our products are water-based, low-VOC, making them non-toxic, environmentally friendly, and easy to use.