Design - Features an extreme low-profile design for aggressive rock crawling. The bumper includes a license plate relocation bracket with a license plate light to make room for up to 37" spare tires. With Or Without Factory Sensors - For models equipped with factory sensors, we included sensor cutouts to retain full functionality of the feature. For models without factory sensors, we include sensor hole plugs for a clean look. Safety - Toward each side of this rugged, Jeep bumper are 1-inch thick mounts that take ¾-inch D-Rings with ⅞-inch shackle pins. These can be used as anchor points for recovery situations. Install - Our FS-15 Series Rear Bumper is fully bolt-on, with no modifications necessary. Inside the bumper are welded zip-tie tabs for clean wire management. Check out our install guide down below! Compatibility - Our FS-15 Series Rear Bumper is compatible with the 2018-2026 Jeep Wrangler JL. The factory hitch and harness fit perfectly in an accessible position beneath the FS-15. Our FS-15 Series JL Rear Bumper features an extreme, low-profile design suited for aggressive rock crawling. The bumper includes a license plate relocation bracket with a license plate light to make room for up to 37-inch spare tires above the bumper. The factory hitch and harness fit perfectly in an accessible position beneath the FS-15. For models equipped with factory sensors, we included sensor cutouts to retain full functionality of the feature. For models without factory sensors, we include sensor hole plugs for a clean look. Toward each side of this rugged bumper are 1-inch thick mounts that take ¾-inch D-rings with ⅞-inch shackle pins. These can be used as anchor points for recovery situations if you or your trail buddy get stuck on an obstacle. The inside of the bumper includes welded zip-tie tabs for clean wire management of the license plate light or other optional accessories. Finished in a micro-texture black powder coat, this bumper features a fully bolt-on installation.