Superior Adhesion: Our peel and stick molding trim with a super sticky self-adhesive acrylic tape, that doesn't easily peel off and no residue when removing. During chillier days, the adhesive can be heated by the hair dryer to enhance the viscosity. Flexible Vinyl Molding Trim: The wall trim is made of high quality vinyl material, which is durable, flexible and scratch-resistant, also good performances of heat, water-resistance. The floor trim is easy to clean with a wet rag if there are stains. Toe Design: This peel and stick vinyl baseboard molding trim 4 inch features toe design, it can cover the gaps and defects perfectly. Besides, it can effectively prevent dust accumulation, making your home tidier and cozy. Easy to Install: Enjoy the simplicity of our user-friendly design! Just measure, cut to your desired length, then peel off the adhesive backing, and effortlessly apply it to any smooth, dry, and clean surface. Decorative Baseboard Trim & Widely Used: The rubber peel and stick baseboard trim is widely used as decoration and wall base protection for home, office or school, etc. The flexible baseboard molding trim adheres well to almost any smooth surface, including plastic, tiles, marble, glass, metal, wood, and walls. "

★Features:

▶ Superior Adhesion: Our peel and stick molding trim with a super sticky self-adhesive acrylic tape, that doesn't easily peel off and no residue when removing.

▶ Flexible Vinyl Molding Trim: The wall trim is made of high quality vinyl material, which is durable, flexible and scratch-resistant, also good performances of heat, water-resistance.

▶ Toe Design: This peel and stick vinyl baseboard molding trim features toe design, it can cover the gaps and defects perfectly.

▶ Easy to Clean: When something dirty, just wipe it with a clean damp towel.

Material: PVC

Length: 20 ft (6 m), 40 ft (12 m), 60 ft (18 m)

Width: 4 inch (10 cm)

★Easy to install:

1. Clean up the walls.

2. Cut to desired length.

3. Peel off the red film.

4. Stick it on the wall, and press repeatedly to make it fully contact the wall.

★NOTES:

1. Since the wall base comes in a rolled form, it may have a natural curve. To ensure proper adhesion, roll it in the opposite direction to relieve tension. For optimal results, let the trim lie flat for some time before installation. If needed, use a heat gun or hair dryer to warm any curved sections to make them more flexible.

2. In temperatures lower than 18°C, preheating the adhesive backing with a hair dryer is recommended to improve bonding performance.

3. Apply the wall base fully against the wall and press firmly back and forth to secure it in place. For maximum stability, allow 24 hours for the adhesive to set completely before testing its adhesion.

4. On powdered walls, rough cement surfaces, uneven walls, damp areas, wall coverings, or stickers, the adhesive strength may be slightly reduced. For best results, apply additional glue during installation and use a hot air blower to enhance adhesion.

"