39MM x3 wheel bearing greaser is a clever tool to make a tough job easy, helps you save lots of time greasing your wheel bearings that should have been done from the factory. It will fit perfectly easy to use With Kemimoto Maverick x3 wheel bearing greaser, you could see the grease in the bearing after. The O-ring seal design enables you to save grease and prevent grease from seeping out during use There is not very much grease in the bearings from the factory. Having a greaser tool for Maverick x3 makes your wheel bearing greased and run smoothly quickly, which is a lot cheaper than having to replace the dried-up bearings The material of X3 wheel bearing grease is made of aluminum, which is remarkable for resisting corrosion 39 mm greaser tool is designed for long-term use. Knurled surfaces help you install grease grab it tightly and take it out easily X3 wheel bearing grease is a must-have addition to your toolbox if you own a Maverick X3 MAX XRS XDS RC Turbo R. Note: 39mm wheel bearing grease is not compatible with 2017- 2022 Can-Am Maverick XXC and OE Replace 293350109 Do your bearings constantly break down? Due to lack of grease? Do you need to go to the factory frequently to replace the bearings? Do you think that is wasting time and money? Do you want to keep your beloved vehicle wheel bearings greased and running smoothly really quickly? The best maintenance purchase for servicing your X3 SxS bearings is coming! Everybody with a maverick x3 should own this 39mm wheel-bearing grease. There is no need to remove the axle with this tool, just only the wheel & hub be removed. Just only remove the wheel and brake caliper, and hub, apply grease in the wheel bearing directly and then insert it into the axle and then inject the grease effortlessly. Tips: When you put the wheel bearing grease in and take it out, make sure your axes shaft is straight. Before using 39mm wheel bearing grease, greasing the front lip and o-rings will allow to lift of the axle shaft slightly and make alignment of the greaser tool easier. We are recommending turning the unit after each pump to equal out grease placement. Due to the axle pointing downwards, when inserting or removing the wheel you need to pull upward. Then you can make removal easier without tools. Do you look forward to it? Do you want to have it? What a time saver. It should be in every rider's toolbox. A must-have! Just go and take it home quickly