For Intex Bestway Coleman or ANY other pools with 1 inch or 1.25 inch hoses A super support for the hose not to kink, no more sagging swimming pool hoses Easy to install - Use the plugs that come with pool to stop the water, take the hose off to put the hose holder on, it will press against the pool wall Helps to straighten up the intake jets on pools, hold the filter hoses up better and keep them from sagging sideways, support pool pumps as well Applicable Hose Size: The swimming pool pipe rack is suitable for pipes and hoses from 0.98 to 1.5 inches diameter, with a stable design to fit most above-ground swimming pool hoses on the market well Advantaged Functions: the swimming pool hose holder can provide strong support for soft hoses, help straighten air inlets on pools, better support filter hoses and stop them from sagging sideways, and reduce pressure on outlet or inlet filter walls, extending the life of the hose and swimming pool, bringing you much convenience in summer Prevent Pipe Slippage: Excessive water pressure will cause the hose to sag, This bracket can be used to straighten the air intake of the swimming pool, better support the filter hoses and prevent them from sagging, extending the life of the hose Easy to Install: firstly, use the pool stopper to stop the water, stick the provided adhesive on the wall of the swimming pool, then place the hose on the pipe bracket and secure the hose firmly with a tie, easy for you to operate, would not spend you too much time and energy Long Service Life: these blue pipe supports adopt quality ABS material, sturdy and lasting, safe and reliable, not easy to deform or break, and resistant to rust or corrode, which can be applied for a long time Cute Mermaid design, fun and gets the job done. Our pool tail hose holders supports are very durable. They are made of ABS plastic from molds. Not 3D printed. They are also weather and fade resistant ensuring years of use and will look brand new. Comes with everything you need. 2 clamps and 2 Pool Tails. Easy to install. Just plug the intake and output holes. Put the clamp on the Pool Tail, remove the hose, put the hose tight against the Pool Tail and tighten the clamp. It is that easy. All you need is a screwdriver and 5 minutes. Reduces the pressure from the intake and output hoses removing tension that can cause sagging, kinking or breaking the hoses and even cracking the pool wall. There are no sharp edges on our Pool Tails. This helps insure you do not have any damage to your pool. Above Ground Swimming Pool Hose Holder Hanger Hooks Vacuum Ground Accessories Water Duty Support Skimmer Nets Heavy Brackets Organizer Rack Tool Pump Holds Stores Intex Summer Waves Bestway Coleman