O-ring Gasket Seal Set Kit Compatible With J-ura, J-uraCapresso, and AEG Espresso machines set of O-rings tool, With grease for lubricating the pistons and cylinder Please note: The kit does not include an aluminum cap for the drain stem. Because we do not recommend replacing the original white cap. For a permanent and reliable repair, you only need to drop a drop of epoxy glue for 5 minutes in the two slots on the original white cap. Turn the cap to allow the epoxy to penetrate all areas inside the cap and let dry. This allows the cap to not fall off. for Brew Group O-Rings: 2x Piston O-Ring: Red (Small O-Ring for lower/small piston, Large O-Ring for Upper/Large Piston). 2x Riser O-Ring: Black. Drainage Valve O-Ring/Seals: 2x Groove Ring Seal: Red. 1x O-ring Inlet Riser Connection: Small Black. High Voltage O-Ring: 10x O-Rings, High Pressure: Red. Water Tank Replacement Seal: 1x Seal - Replace the dry/cracked water tank seal with a new seal. Stainless Steel E-Clips: 2x Stainless Steel E Clips - These clips can break when removing. Used to replace clips that break accidentally. Food Grade Lube: 1x food grade silicon lube for lubricating the pistons, cylinders and O-Rings/Seals. Compatible with machines from the following Jura Impressa series: C Series: C50, C55, C60, C65, C70, C90, C1000, C1300, C1500, C2000, C3000, C5, C9. E Series: E10, E20, E25, E30, E40, E45, E50, E55,E60,E65, E70, E74, E75, E80, E85, E5, E7, E8, E9. ENA Series: ENA3, ENA4, ENA5 Compatible with machines from the following Jura Impressa series: F Series: F50, F55, F70, F90, XF50, XF70, F5, F9. J Series: J5, J6, J7, J9, J9.2, J9.3, J9.4. S Series: S50, S55, S70, S75, S85, S90, S95, S7, S8, S9, S7 Avantgarde, S9 Avantgarde, S9 One Touch. Z Series: Z5, Z6, Z7, Z9. X Series: X30, X70, X90, X95, XS90, XS95, XS90 one touch, XS95 one touch, X5, X7, X9. C-a-ppuccino Maker: 201, 300, 401, 500, 601, 801, 3000, 4000, 5000, 6000, Evolution, M30, Scala, Scala Vario, Ultra.