Dash Cam OBD Hardwire Kit Compatibility: OBD dash cam hard wire charger cable is suitable for the OBD port of most vehicles and is designed for most dash cams, GPS, radar detection, etc. It is compatible with the best dash cam power cord for Jeep Cherokee, Chevrolet, Toyota, trucks, and more, as long as you have an OBD port MODE 1: Press the red button switch to "MODE -": In this mode, regardless of whether the car is turned on or off, the dash cam will maintain 24-hour recording. If the voltage drops below 11.6V, the power will be cut off, suitable for parking monitoring MODE 2: Press the red button switch to" MODE O": this is ACC mode. at this mode your dash camera will turn on/ off when your car turn on/off Special Reminder: 【 MODE Switching 】 When switching between 【MODE 1】 and 【MODE 2】, the OBD adapter must be unplugged and reinserted once, otherwise the mode switching will not working. Specific steps: 1. Pull out the ODB adapter. 2. Switch to the mode that you want. 3. Reinsert the OBD adapter Packaging Content：1 X OBD dashcam hardwire kit (USB Type-C), 1 X Opening Tool Bar, 1 X Micro USB Connector, 1 X Mini USB Connector. The accompanying Micro USB Connector and Mini USB Connector make the OBD hardwired kit a more versatile device, allowing you to easily solve problems, save time, and offer a more cost-effective package Low Voltage Protecting: OBD Power Adapter USB C: OBD2 dash cam power cable, which has a built-in intelligent program control chip with automatic battery voltage detection and low voltage protection, automatically cutting off the power output when the battery voltage is below 11.6V to ensure the vehicle can start normally Only for Charging OBD Power Connector: Obtaining power from OBD interface only, no interference in other OBD data communication Technical Specifications:
Extension cable: 3.5meters(11.5 ft) length
ACC mode Input: 13V-36V Output: 5V/3A
Surveillance mode Input: 11.6V-36V
Output: 5V/3A
Interface: TYPE C USB (obd power adapter usb c)+Micro USB+ Mini USB

One button for Two work modes:
Mode “O”:
ACC mode: When your car ACC is off, the OBD power cable will also power off after 20 minutes.
Mode “—”:
Surveillance mode: When you car ACC is off, the OBD power cable will keep working until detecting the car battery voltage is at 11.6V(low voltage), it will power off after 30 seconds The low voltage protection for mode “—” protect your car from running out the battery, enable you have enough voltage to start the car for next driving.

Attention:
1.Please note that the car OBD, OBD2 power cable is only working for dash cams which range from 12.8V-36V,other voltage range is not supported. The voltage will be converted to 5V output.
Packaging Content：
1 X OBD dashcam hardwire(USB Type-C)
1 X Opening Tool Bar
1 X Micro USB Connector
1 X Mini USB Connector