Package Included: Package includes 1 pcs rubber edge trim, card slot width: 5 mm/0.2 inch, width: 8 mm/0.3 inch, height: 11 mm/0.43 inch, length: 3m/10 ft Material: NBR nitrile rubber, compared with the EPDM edge trim on the market, it has better oil resistance and elasticity, stronger wear resistance and is not easy to age. Easy to install: This rubber edge trim can be easily cut with scissors and is highly elastic and can be bent into any desired angle. Just add glue to the edge and the trim can be installed securely. Wide Application: Edge protector is suitable for most environments. Metal edge protector is suitable for covering the edges of all sheet metal parts: sheet metal edges, panels, doors, steel plates, hatches, glass, table corners, etc. NOTE:When using U channel edge trim, please measure the angle before trimming to avoid swelling caused by mismatched edge angles. Flexible U Channel Edge are a very flexible material. They are widely used in the manufacturing, construction and automotive industries. Rubber Seal Strip can cover keen edges of metal, plastic or glass to prevent accidental cuts or scratches, or be used to seal the edges of car doors and windows to keep out water and noise. They can also protect delicate components in electronic products from damage and add an artistic touch to any space.

Specification
Color: Black
Material: NBR
Card slot width: 5 mm/0.2 inch
Width: 8 mm/0.3 inch
Height: 11 mm/0.43 inch
Length: 3m/10 ft
Trial board range: 4-5mm/0.16-0.2 inch
Packing List: 1 Pcs x Rubber Edge Trim

Advantage
The rubber edge trim can withstand temperatures from -22F to +212F, is resistant to high and low temperatures, has good oil and wear resistance, is not easy to age, and has a long service life. The rubber trim can surround the keen edge and make it soft and smooth. It not only protects personnel, but also reduces the wear of the edges. At the same time, it can also isolate noise and dust.

Instruction
"How to install a rubber edge trim
1. Clean the edge where the edge protector is to be installed
2. Measure the angle and cut a 90° angle with right-angle scissors
3. Put the U-shaped groove of the metal edge protector on the edge
4. Apply glue to the inside of the U-shaped groove to complete the installation"

NOTE:When using U channel edge trim, please measure the angle before trimming to avoid swelling caused by mismatched edge angles.