PLEASE NOTE: Shark fin antenna is not suitable for KIA optima, Hyundai Sonata. In order to avoid inconvenience to you, please check the size before ordering. If the size of your original antenna's base is bigger than 2.48inch x 3.19'inch (63mm x 81mm), this shark antenna will not fit your car. Fit for most cars having a slightly curved or flat roof surface to install the shark fin antenna. This Shark Fin Antenna with AM/FM signal reception function and decorate your car, truck, SUV, etc. It can't emit radio frequency energy Material: High quality ABS Material. Tips: Due to the different resolution of the display, there may be color difference, please pay attention. The wire was surrounded by the rubber to prevent it from the osidation, make the antenna more durable. Easy installation with the self-adhesive, no drilling required, just clean and dry your car, stick the fin on the surface, strong paste, not easy to fall off.Come with the needed screw to connect the wire to your antenna base and adhesive tape to ensure a good seal when mounting it over your existing antenna base.

Features:

- Fashion Shark Fin Design

- The design is amazing, concision and modern. Make your car cool and distinctive.

- AM/FM Radio Signal

- This Shark Fin Antenna with FM/AM connectioncable inside. It can enhance the signal and achieve the purpose of decoration.

Durable:

- Durable item, classic, handy and beautiful.

- Easy to Install

- Double-sided adhesive tape, easy installation, no drilling required.

Specifications:

Style: Shark Fin

Overall size: 16cm*7.0cm/6.3in*2.75in

Intermediate size: 8.1cm*6.3cm/3.19in*2.48in

Note: Please check the size before ordering. Not exactly the bottom of the rectangle, so the width of the edges and the middle are different.

Material : High-Quality ABS Material

Package Included:

1 x Shark Fin Antenna

1 x Double Sided Adhesive Tape

1 x Bolt

2 x Screws

How to Install a AM/FM Radio Signal Shark Fin Car Antenna

1.Remove Original Antenna

- Compare the size and check the car model first.

- Remove the original antenna

- Screw the nut from the new antenna

- Install the screw

- Fix the signal wire with the screw

2.Install the New Shark Fin Antenna

- Confirm the position to install the antenna

- Clean the car surface and increase the viscosity

- Peel off one side of the adhesive and stick it on the bottom of the fin

- Put on the screw and tighten the screw

- Peel off the other side of the adhesive and stick it on the surface of the car.

3.Finish the Installation

- Please confirm your size before ordering it.

- All dimensions are measured by hand, there may be small deviations.

- Don't wash the car within 24 hours after installation, so tape can hold on its place best.

Note: Just be sure to wipe the area down with alcohol before you place th