【Model W2】Power: 90~100 Watt, Length: 1200mm. This CO2 laser tube is a part of the CO2 laser cutter engraver and cutting engraving machine. The laser tube is connected by a screw and terminal, easier to connect, without poor contact, and no glue filling. 【Special Coating Technology and Larger Diameters】The RECI CO2 laser tube use an internal discharge tube coated with a nano-gold catalyst. The larger diameter can fill more CO2, making the power more stable and the service life longer. It is a better choice for people with heavy workloads and long working hours. 【Water Cooling Technology】Professional water-cooled fully sealed CO2 glass laser tube. TEM00 mode laser spot is excellent and the laser energy is strong. 【Attention to Details】There is a metal protective cap and a plastic cap at 2 ends of the laser tube to protect it. The positive protective connector head and wire with terminal are for the anode; the wire with terminal is for the cathode. Both are given as present. 【Customer Service Support】Lead Time: 7-10 Business Days. Each tube is tested before shipment, and we will provide safe packaging. If damaged during transportation, please contact us here for after-sales service. 18 months maintenance and replacement period. Installation Instructions
1. Determine the positive and negative poles of the laser tube (the end of the spiral glass tube inside the tube is positive and the light exit is negative).
2. The original positive and negative wires of the machine can be connected to the corresponding joints of the laser tube.
3. Insert the inlet and the outlet water pipe into the water, usually the positive high-pressure line is the inlet, light outlet is the outlet, pay attention to the low into the high ( otherwise it is easy to cause cracking, burst pipe because the water is not filled ).
4. Adjust the optical path with the laser and test switch on the machine. The final target is to make the laser point enter from the middle of the entrance hole of the laser head, and then adjust the vertical optical path.
5. When the light path is adjusted, you can use it for cutting, engraving and marking.
6. We can provide installation support through video and lifetime technical support.
Tips & Warning
1. You must check whether the water circulation cycle is normal and no bubbles before each use.
2. The cooling water should have at least 20 liters, water temperature under 86℉ or 30℃, change water every 2 weeks.
3. Please keep the high Volt electrode dry and clean, and keep it away from the metal to avoid damage to the main board.
1. Determine the positive and negative poles of the laser tube (the end of the spiral glass tube inside the tube is positive and the light exit is negative).
2. The original positive and negative wires of the machine can be connected to the corresponding joints of the laser tube.
3. Insert the inlet and the outlet water pipe into the water, usually the positive high-pressure line is the inlet, light outlet is the outlet, pay attention to the low into the high ( otherwise it is easy to cause cracking, burst pipe because the water is not filled ).
4. Adjust the optical path with the laser and test switch on the machine. The final target is to make the laser point enter from the middle of the entrance hole of the laser head, and then adjust the vertical optical path.
5. When the light path is adjusted, you can use it for cutting, engraving and marking.
6. We can provide installation support through video and lifetime technical support.
Tips & Warning
1. You must check whether the water circulation cycle is normal and no bubbles before each use.
2. The cooling water should have at least 20 liters, water temperature under 86℉ or 30℃, change water every 2 weeks.
3. Please keep the high Volt electrode dry and clean, and keep it away from the metal to avoid damage to the main board.