Electric Motor E Bike Hall Element Circuit Board 41F Hall Plate Sensor PCB Direct Drive Hub Motors Suitable for brushless motor within 1000W Complete with wire and insulated 41F sensors Motor Hall installation instructions:
1. Remove the motor housing screws and open the motor;
2. Pull out the middle steel ring;
3. Remove the old Hall and insert the new Hall into the original card slot. Be careful during installation. Do not use excessive force, and then fix it with glue or tape; (Note: do not apply glue to the front of Hall)
4. Wiring: red and black (positive and negative wires) shall be connected according to color, and yellow, green and blue wires shall be connected at will; (Warm prompt: the yellow green blue lines are connected in the original order, which can avoid multiple wire adjustment and phase change)
5. When installing the motor cover, it is better to apply sealant to make it waterproof, which can effectively reduce the short circuit caused by water ingress into the motor.
1. Remove the motor housing screws and open the motor;
2. Pull out the middle steel ring;
3. Remove the old Hall and insert the new Hall into the original card slot. Be careful during installation. Do not use excessive force, and then fix it with glue or tape; (Note: do not apply glue to the front of Hall)
4. Wiring: red and black (positive and negative wires) shall be connected according to color, and yellow, green and blue wires shall be connected at will; (Warm prompt: the yellow green blue lines are connected in the original order, which can avoid multiple wire adjustment and phase change)
5. When installing the motor cover, it is better to apply sealant to make it waterproof, which can effectively reduce the short circuit caused by water ingress into the motor.