WALL MOUNT FOR BETTER WIFI: Get the most from our Eero 6 Mesh WiFi system by placing it higher up on your wall for maximum range and reception. When left on tables, the low level doesn’t provide for the ideal situation for your Eero 6 to reach its full potential. NO TOOLS, NO HASSLE: Don’t look for that drill or call your buddy over to make swiss cheese of your walls, simply remove the tape backing and apply our mount to your desired location, wait at least 2 – 12hrs for the VHB to reach max bond strength and you’re good to go. VHB tape is super strong and is very hard to pull off by hand when fully bonded, but can be easily removed with use of a hair dryer. CUSTOM DESIGNED: Our cradle design has been custom made to the curvature of the Eero 6 body shape, holding it firmly but with minimal footprint. Will look good in any setting in your home or office. DESIGNED FOR RANGE NOT INTERRUPTION: Our wall mount has been designed to not impede the WiFi signal of your Eero 6 and Eero 6 extender. Not Compatible with eero 6 Pro or Beacon IMPORTANT: Do not install on wallpaper/painted/plastered wall, as the strong adhesive and weight of Eero may break/rip off wallpaper/painted/plaster and come off! Ideally remove any wallpaper/painted/plaster from the area and affix it to the bare wall where you wish to attach the mount. Wall mount holder for the Eero 6 Mesh WiFi router & Eero 6 extender home system. Easy to install, no tools required. Uses strong VHB mounting tape made by 3M which, once left to set for a few hours, will remain in place for years. Designed for Eero 6 router and extender. Not Compatible with original Eero, Eero Pro 6 or Beacon