Fit Models: 506,510,511H,547,548,706,709,748,749,806,808,847, 848,1147,1148,2010,2011,5006,5047,5048,5049,EcoVac 146-149, VacuFlush 168,606,647,648,1006,1008,1047,1048,1049,1106,5146, 5147,5148,5149 Suitable Brands: Fits for most pedal-flush Do-metic, SeaLand, VacuFlush and Traveler brand toilets.DO NOT include overflow holes inside the toilet bowl Super Durable 385316140 RV Toilet Rubber Seal: Made of durable rubber to ensure high performance,soft,durable,anti-Friction,good tightness to ensure seal properly,no worry about leaking.And it keeps the water in place and the stink out,save money on a new toilet Easy To Install: 385316140 RV Toilet Rubber Seals are easy to use,save your time and energy,bring convenience for your life. Notice:Does not replace bowl seal on 300,310,320 series Do-metic toilets After-sales Service: Sikawai strive to maintain fairness and honesty with all customers, and will make your satisfaction our top priority, If you have any problems, plase tell us through Amazon

385311462 RV Toilet Rubber Bowl Leak Seal Kit Replace For Do-metic For Do-metic / 

Sealand / Mansfield / VacuFlush and Travel Trailer RV Camper Toilet by Sikawai

Fit for Do-metic/Sealand/VacuFlush and travel trailer RV Camper toilet that do not have the overflow holes inside the toilet bowl

Suitable Models:

506+,510+,511H,547+,548+,706,709,748,749,806,808,847,848,1147,1148,2010,2011,5006,5047,5048,50

49,EcoVac 146-149,VacuFlush 168,606,647,648,1006,1008,1047,1048,1049,1106,5146,5147,5148,5149

Installation Tips:

1.Turn off the water supply

2.Press the flush petal and drain water from toilet bowl,remove pedestal cover

3.Loosen stainless steel band and remove plastic half clamps that hold china bowl and plastic base 

together

4.Tilt China bowl forward,grasp vacuum breaker attached to back of toilet and pull it out off toilet.Set toilet 

bowl aside

5.Remove both old seals and place new seals with TISH SIDE UP on top of thin seal with raised circle of 

thin seal protruding up through center of large disc

6.Place seal and disk assembly on top of flush ball.Align notch on edge of large disc with pin on edge of 

base

7.Put china bowl back on toilet base,aligning notch with pin on base,and centering the bowl outlet over 

the flush ball.Re-insert vacuum breaker into back of toilet,pushing it all the way into the rubber sealing 

grommet

8.Re-install plastic half clamps under loosend steel band,making sure tabs interlocks at center front of 

toilet .There will be a small gap at rear of toilet

9.Tighten stainless steel band clamp to a minimum torque of 65 pounds

10.Reinstall pedestal cover and turn on water supply