Working voltage: DC12-24V Load type: LED lamps and various household appliances Load power: ≤50W Touch head: 50X34X10mm This switch is an isolated touch sensor switch, suitable for all kinds of lamps with medium (such as glass, acrylic, plastic, ceramic, etc.) Features:
Isolation touch sensor switch, in the case of isolation protection, it can trigger the switch to work without touching metal parts
Touch switch function: one on and one off
To ensure the safe use of electricity by users, there is a surge absorber, which can effectively prevent outside interference.
It is suitable for all kinds of lamps with medium (such as glass, acrylic, plastic, ceramic, etc Installation steps:
Note: Please cut off the main power switch before installation.
Connect the black and red wires of the switch to the power input, and the other set of red and blue wires are the output to the light strip.
Design a touch point on the mirror surface. The size of the touch point is straight through 15-20mm. First of all, the mercury around the touch point of the lens must be removed. The width of the removed mercury is preferably 1.5-2CM. The removed mercury part can also be backlit. Through the display, the touch position can be seen at a glance, which is beautiful and convenient to find the touch switch position.
Make a center cross on the touch point when installing the switch, there are three arrow lines on the switch box, and the three arrow lines should be aligned with any three lines of the cross line on the touch point, (because the center diameter of the touch switch board is 10mm Is the touch-sensitive area, so be sure to align the touch-sensitive area on the touch switch board with the touch point of the mercury part knocked out by the mirror surface). It can only be touched after being aligned. The touch frame comes with adhesive, viscose There is a sticker on the surface, remove the sticker, put it on the lens to mark the position, 3 points on the bracket are aligned with the center point of the mark, and then put the switch into it. It is ok to test the switch after it is attached. In order to ensure that it does not fall off permanently, you can use glass glue to fix the bracket again.
Isolation touch sensor switch, in the case of isolation protection, it can trigger the switch to work without touching metal parts
Touch switch function: one on and one off
To ensure the safe use of electricity by users, there is a surge absorber, which can effectively prevent outside interference.
It is suitable for all kinds of lamps with medium (such as glass, acrylic, plastic, ceramic, etc Installation steps:
Note: Please cut off the main power switch before installation.
Connect the black and red wires of the switch to the power input, and the other set of red and blue wires are the output to the light strip.
Design a touch point on the mirror surface. The size of the touch point is straight through 15-20mm. First of all, the mercury around the touch point of the lens must be removed. The width of the removed mercury is preferably 1.5-2CM. The removed mercury part can also be backlit. Through the display, the touch position can be seen at a glance, which is beautiful and convenient to find the touch switch position.
Make a center cross on the touch point when installing the switch, there are three arrow lines on the switch box, and the three arrow lines should be aligned with any three lines of the cross line on the touch point, (because the center diameter of the touch switch board is 10mm Is the touch-sensitive area, so be sure to align the touch-sensitive area on the touch switch board with the touch point of the mercury part knocked out by the mirror surface). It can only be touched after being aligned. The touch frame comes with adhesive, viscose There is a sticker on the surface, remove the sticker, put it on the lens to mark the position, 3 points on the bracket are aligned with the center point of the mark, and then put the switch into it. It is ok to test the switch after it is attached. In order to ensure that it does not fall off permanently, you can use glass glue to fix the bracket again.