Vehicle Fitment: Compatible with Gloss Black Grille Overlay for 18-21 Chevrolet Traverse, precisely engineered for perfect fitment Sturdy Design: Made of high-quality ABS, Gloss Black finish will absolutely upgrade your exterior appearance Stylish Design: The grille will improve the appearance of your car and enable airflow into your vehicle to cool down your radiator and engine Easy Installation: It fits right over the top of your grille without any unscrewing or disassembling. Just snap on with adhesion IATF16949:2016 certified factory, approved for manufacturing OEM accessories Guaranteed to be the best fitting grille overlay on the market. Utilizing our patented SNAP-ON technology or 2-sided adhesive, Trim Illusion patented grill covers and inserts have the best cover and appearance than ever before. The pattern allows not just good looks to your car but also enables airflow into your vehicle to maintain airflow to cool down the radiator and engine. Precisely engineered gives perfect fit over the front Grille without any extra effort to unscrewing or disassembling. Easy to install with quick adhesion glue. IATF16949:2016 certified factory, approved for manufacturing OEM accessories. Please follow installation guides as below for perfect and long-lasting fit: 1. Carefully test fit product on application site before removing the double-sided tape or the protective film. If you suspect fitment to be incorrect, contact us immediately and share supporting images. 2. Inspect the application site to make sure it is free of dirt, oil, grease, or wax. Clean the application site with water-based solutions like Windex to avoid damaging the finish then dry the surface well. 3. To start the installation, make sure you are in a 50°F or above environment for glue to properly adhere part to surface. Apply included or preferred adhesive promoter to application site. 4. Remove protective film from adhesive compound. In case of residue on the chrome finish, please use a microfiber cloth and alcohol to clean the surface. 5. Carefully align product on application site, pressing firmly over the entire site to ensure proper adhesion. If you make a mistake, you can use a heat gun or blow-dryer/hairdryer to loosen the adhesive to remove the part from the application site. Also, double-sided tape or promoter (sold in hardware stores) can be reapplied or added to missing areas if necessary. 6. Snap-On Grille Overlay must be firmly pressed until it "Snaps" into place. GENERAL MOTORS TRADEMARKS USED UNDER LICENSE TO TRIM ILLUSION