North- Boat Wedge transom saver, works with all three ram Yamaha outboard motors.
The package also include the centering clips to keep your outboard straight when towing.
It sames to M-Y Wedge transom saver
Fits :
1、Yamaha outboards (Including SHO) outboards 115 HP to 350 HP（2 / 3-Ram Trim / Tilt Systems）
2、Mercury outboards 135 HP to 300 HP （2 / 3-Ram Trim / Tilt Systems）
3、Honda outboards 90 HP to 300 HP （2 / 3-Ram Trim / Tilt Systems）
4、Johnson outboards 150 HP - 300 HP （2 / 3-Ram Trim / Tilt Systems）Works on these models: Carb. EFI, Opti-Max, SHO,2-Stroke, 4-Stroke, Hpdi, ETEC, Ficht and Offshore, with 3 RAM SystemsJohnson 4-Stroke outboards 150 HP - 300 HP with 3-Ram Trim / Tilt Systems
5、Suzuki four stroke outboards DF140 HP - DF300 HP （2 / 3-Ram Trim / Tilt Systems）
Installation Notes:
Install on Trim / Tilt Switch Side (Normally Starboard Side of Mercury / Honda / Johnson 4-Stroke, Johnson Outboards)
Install on Trim / Tilt Switch Side (Normally Port Side of Yamaha / Suzuki Outboards
F300-F350 V-8 models need 2 m- units, port and starboard)
1. Trim outboard to up position
2. Simply slideNorth-Boat Wedge on Trim / Tilt switch side normally Port side (see note) of Yamaha / Suzuki and normally Starboard side of Mercury / Honda / Johnson over Trim/Tilt piston rod of Lower unit
Note: (On Yamaha/Suzuki the trim/tilt switch may be on the Starboard side, if there is a grease zerk where the m- meets the swivel bracket, the m- must go on the Port or Starboard side depending on where the grease zerk is)
3. North-Boat Wedge will position and self-center, slide completely down.
4. Trim outboard down until the rubber begins to compress
5. To remove North-Boat Wedge simply trim outboard to up position and remove
6. Store North-Boat Wedge in any boat compartment for convenience
Note: Manufacturer recommends that you No