1. this switch is an isolated touch sensing switch, suitable for media (such as glass, acrylic, plastic, ceramic, etc.) lamp body on all kinds of lamps, in the case of isolation protection without touching the metal parts through the glass can be induced to trigger the switch work, touch function, high safety performance. Switch use no mechanical wear, long life, switch installed after the mirror front can not see the switch accessories, just see the backlight revealed the touch mark, beautiful 2. The on and off status indicator background light is designed on the touch switch board, and the background light and the touch switch are designed as one. When the power supply and switch are connected, the indicating background light on the switch board will be blue after the power supply is powered on. (Optional background color, such as red, blue, white) 3.touch switch function: when the body touches the light for the first time, the background light indicates red, touch the light again, the background light indicates blue, and cycle in turn. 4.can ensure the user's safe electricity, there is a surge absorber, can effectively prevent the outside world and the outside interference. 5. Suitable for all kinds of lamps with media (such as glass, acrylic, plastic, ceramics, etc.). 6. wiring mode: red and black lines are connected to "+, -" DC: 5V, 12V-24V input, red and blue lines are "+, -" DC: 5V, 12V-24V output is connected to LED light belt, black touch head is installed on the back of the mirror. Working voltage: DC: 5V, 12-24V optional. Load type: LED light source and various DC electrical appliances. Load power: ≤50W, ≤100W optional

Installation steps:

Note: Please turn off the main power switch before installation.

1. Connect the red line and black line on the host to "+, -" DC: 12-24V input, and the red line and blue line to "+, -" DC: 12-24V output to the LED light belt.

2, design a touch point in the mirror, the size of the touch point straight through 18-20mm, first of all, the mercury around the touch point of the lens off, off the mercury width is best 1.5-2MM, off the mercury part just backlight can also be revealed, at a glance can see the touch position, that is beautiful, but also convenient to find the touch switch position.

3, when installing the switch, make a central cross on the touch point. There are three arrow lines on the switch card slot, and the three arrow lines should be aligned with any three lines of the cross line on the touch point. (Because the most central diameter of the touch switch board is 15mm for the touch sensing area. Therefore, the touch sensing area on the touch switch plate must be aligned with the touch point of the mercury part of the mirror), and it can be touched only after alignment. The card slot comes with adhesive, and there is a sticker on the surface of the adhesive. Remove the sticker and stick it on the opposite side of the lens, and press the switch box into the card slot after pasting. It can be glued to the slot in other ways and then fixed.